[Top] [Prev] [Next] [Bottom]
Page 36 out of 51 total pages , Page 2 out of 2 pages in this chapter

Configuring PPPoE settings

To configure PPPoE:

  1. Go to the SystemLAN screen.
  2. Choose a public interface, select PPPoE from the Protocol list, and click on Apply.
  3. Figure 17 System LAN screen

  4. On the Add PPPoE Interface screen, select permit all for the Interface Filter and click on OK.
  5. From the SystemLAN screen, click on the Edit button, and the Edit PPPoE Interface screen appears.
  6. Figure 18 Edit PPPoE screen

    1. Enable the administrative state to activate.
    2. Enable On Demand. The default is disabled (nailed PPPoE service).
    3. Enter the Idle Timeout parameter value from the range specified on the screen to specify n minutes of inactivity after which to tear down the connection.
    4. Enter a value from the range specified on the screen to indicate the cost of the connection.
    5. Optionally, enter a service name that describes the connection. You should use this field only if the ISP has provided a service name.
    6. Enter the local IP address, which is dynamically assigned to the interface. The default 0.0.0.0 indicates that the address will dynamically come from the ISP server.
  7. For PPP Authentication Settings, click on Configure. The default authentication is None. The PPP Local Authentication screen appears.
  8. Figure 19 PPP Local Authentication screen

    1. Select either PAP or CHAP.
    2. Enter the UID.
    3. Enter a password.
    4. Click on OK.
  9. For PPP Advanced Settings, click on Configure. The PPP Advanced screen appears.
  10. Figure 20 PPP Advanced screen

    1. Configure the appropriate LCP and IPCP options.
    2. Click on OK.



[Top] [Prev] [Next] [Bottom]
Page 36 out of 51 total pages , Page 2 out of 2 pages in this chapter

Configuring Tunneling Protocols and Advanced WAN Settings for the Contivity Secure IP Services Gateway